5/4/2023 0 Comments Printfab mac keyWhen you go to print in an application, select the PrintFab printer, then under “Main” select the paper name you gave in step 6 and everything should be set for you to print. Select “Close” then “Exit”, then “OK”, then “OK”.ġ6. Select it then click “Open”, then “OK”.ġ5. In Windows it usually is in C:\Windows\System32\spool\drivers\color. Find where you have the profile created in step 9. Select the name you gave it in step 6, click “Import Color Data”.ġ4. Open the PrintFab Control Center again, select the printer, and select “Profiles”.ġ3. Print the test charts and generate the profile using that paper name.ġ2. This will gray out all selections since that paper does not have a profile yet. When you go to print the test chart, under “Main” and “Paper” select the name you created in step 6. Start up ColorMunki program and select the PrintFab printer.ĩ. Click “Continue”, “OK”, “Close”, and “Exit”.Ĩ. (I’ve never had to use less.) and fill out names to whatever you will remember.ħ. For glossy paper select “Photo Black”, “Glossy Paper”.Ĥ. Open the PrintFab Control Center, select the printer, and select “Profiles”.ģ. PrintFab will use 16bits both on Windows 8.1 and on a Mac.)Ĭreating PrintFab Profiles with ColorMunki Photoġ. (You may want to use a resolution less than 2880 and 16 bits because it takes awhile to spool - like go out to lunch and come back time. I was asked if I could write down the steps needed to create and use a profile for PrintFab using a ColorMunki Photo.
0 Comments
Leave a Reply. |